|
|
The rear compartment is PU skinned for wash-down purposes, with storage shelves, a hand basin with hot water, & storage cage above for carrying loose items. |
|
The f ront compartment has four dog cages with access to two, from either side of the vehicle. There is drainage in each cage, an electric extract and blow roof mounted fan, an interior light with independent switch and a roof mounted xenon beacon. |
 |
The vehicle is ply lined with complete wash-down facility. Pest control section has shelving against the center bulkhead and shelves to tops of wheel-boxes. Securing points for sprays etc., electric wash hand basin with loose bowl attached to the rear door. Mesh divider on top of rear compartment for separate storage. Roof mounted beacon located at the rear. |
 |
The DOG SECTION, has steel cages dipped and gold passivated for strength and protection against rust. there is access to two cages on each side of vehicle. A bulkhead between the driver and dog section is GRP skinned and sealed to reduce noise. An electric blow and extractor fan is roof mounted above the cages to give ventilation. Center and rear dividers are solid galvanized sheet, and the complete unit can be dismantled. the cage roosf are in line with the rear section to give stowage of long items of equipment. An interior light is attached to the front bulkhead. |
|
This vehicle is kitted out for the installation and maintenance of poster hoarding's. The interior is completely lined and coated with a Polyurethane substance, and sealed to give a water-proof interior. A false floor is fitted with a polyurethane water tank and outlet for washing down. A stowage rack is fitted to the offside to accommodate a step-ladder - and storage provided for smaller items. A storage box is fitted to the nearside for holding cleaning fluids and other small items. A double fluorescent light is fitted to the inside ceiling to give ample light during winter hours. This is wired into the rear door closures to ensure the light is not inadvertently left on. A Xenon beacon is roof mounted with a switch in the cab. Detachable frames are fitted across the vehicle to allow the carriage of posters.
The vehicle has been painted in the clients colours and liveried. |
|
This specification includes a full ply-line fitting with a bulkhead to allow for the drivers seat to be raked back. All ply is far eastern BB/CC grade finished with dark oak stain, all door opening are aluminium capped where possible. Various storage boxes are fitted to the floor. A frame is mounted to the offside to provide stowage for a ladder. The offside is fitted with a slide rack containing multi-store bins and a basket. A twin fluorescent light is wired into the rear door closer to prevent the light being accidentally left on and draining power from the battery. |
|
|
(Click this link to download our Dog-Van conversion brochure)
A double dog cage is shown fitted into the rear of a Renault Kangoo van. The interior has been ply lined and PU skinned to provide a wash-down facility. The floor was then overlaid with a detachable rubber mat. There is storage above the cage for further equipment. Two vents were cut into the sides of the vehicle to give increased ventilation which was boosted with an electric roof mounted vent - with the option to draw air in or expel air out. The interior ceiling mounted light had the switch wired into the rear door to enable automatic switch off. An over-ride switch was also incorporated in the cab should it be necessary to leave the light on. |
|
A multi-purpose vehicle with water tanks, detachable glass frails sliding rack and many other features. |
|
|
|
